SECTION 5 - SAFETY

คำชี้แจง

- ถ้าไม่กรอกทั้งชื่อ และนามสกุลของผู้ทำข้อสอบ ระบบจะไม่ตรวจข้อสอบให้

- ส่วนนี้จะไม่มีการบันทึกผลสอบ หากต้องการบันทึกโปรดสมัครสมาชิก

- ถ้าทำข้อสอบไม่ครบ ระบบจะไม่ตรวจข้อสอบให้

- ผู้ทำข้อสอบจะมีเวลาในการทำข้อสอบเพียง 30 นาที หากเกินเวลา ระบบจะไม่ตรวจข้อสอบให้

- เกณฑ์ตัดสินผ่านการทดสอบอยู่ที่ร้อยละ 90 หรือ 18 ข้อขึ้นไป

32841 SECTION 5 - SAFETY

หน้านี้แสดงครั้งละ 20 ข้อบนเครื่องพิวเตอร์ทั่วไป

ส่วนนี้จะไม่มีการบันทึกผลสอบ และแสดงเฉลยแบบทดสอบ หากต้องการบันทึก และรายงานการทำแบบทดสอบ โปรดสมัครสมาชิก

1. 5.79 Which of the following exposure limits for H2S (for use with respirators) are correct? a. 500 ppm maximum exposure when using a full face respirator b. 100 ppm maximum exposure when using a half-mask respirator c. A self contained breathing apparatus must be used if the exposure exceeds 500 ppm d. Only a self contained breathing apparatus is permissible for any exposure above the permissible exposure limit
2. 5.55 Which of the following conditions can cause false readings on an explosion meter? a. Low hydrocarbon vapor content b. High moisture content c. Low oxygen content d. Both b. and c. are correct
3. 5.85 When working you must always wear a H2S monitor. a. True b. False
4. 5.70 What are the effects of acute exposure (short term) to benzene? a. Shortness of breath, irritability, headache, nausea, dizziness, intoxication b. Irritation of the eyes, nose and respiratory tract c. Convulsions and loss of consciousness d. Answers a., b. and c. are all correct
5. 5.10 The responsibility for an inspector complying with the safety regulations in any terminal belongs to? a. The terminal staff b. The terminal s safety officer c. The inspector d. The inspector s manager
6. 5.04 What is the minimum personal protective equipment required when sampling? a. Gloves, respirator, hard hat and SCBA b. Gloves, eye protection, hard-hat, flame retardant uniform & safety shoes c. Gloves, face-shield and sun glasses d. Gloves, uniform and SCBA
7. 5.02 Regardless of the product, and in accordance with IP475/ISO 3170, what is the absolute maximum level to which sample containers must be filled? a. 50% b. 80% c. 95% d. 100%
8. 5.36 What is the most informative source of information about the hazards of a product or chemical? a. The job sheet b. The Bill of Lading c. The Safety Data Sheet d. The operations supervisor
9. 5.58 The appearance and characteristic odor of benzene is? a. Clear colorless liquid with a sweet odor b. Clear colorless liquid with a sour odor c. Light brown liquid with no distinguishable odor d. Light brown liquid with a strong pungent odor
10. 5.23 While sampling a crude ship, the fire alarm sounds. What action should be taken? a. Grab a type C fire extinguisher and assist the crew b. Close the hatch and call for the launch c. Continue sampling because the crew will take care of the fire d. Immediately secure your area and report to the muster point
11. 5.35 What is the correct source of information about the hazards of any product being inspected? a. The inspector s supervisor b. A knowledgeable chemist c. The inspector s previous experience d. Safety Data Sheets
12. 5.27 What can help prevent a build-up and/or discharge of static electricity when sampling? a. Use of a sampling cord made of synthetic fibre b. Tying the end of the sampling cord to the railing of the tank c. Use of a sampling cord that contains no synthetic fibre d. Holding the sample cord against the gauge hatch throughout the sampling operation
13. 5.29 What should you do to avoid the build-up and/or discharge of static electricity when using a portable electronic thermometer (PET)? a. Hold on to the railing or other metal part of the tank while using the PET b. Attach the ground wire of the PET to the tank before opening the gauge hatch then slowly lower the probe assembly into the oil c. Since the probe is plastic and does not conduct electricity, no static electricity can form d. Either a., b. or c. is acceptable
14. 5.22 When using a metal tape to gauge a tank, the tape should always stay in contact with the gauge hatch. a. True b. False
15. 5.42 Products have defined limits of combustion. What are these? a. The Permissible Exposure Limit and the Threshold Limit Value b. The Lower Explosive Limit, Upper Explosive Limit and the Flash Point c. The Flash Point and the Threshold Limit Value d. The Permissible Exposure Limit and the Lower Explosive Limit
16. 5.66 What is the appearance and characteristic odour of benzene? a. Clear colourless liquid with a sweet odour b. Clear colourless liquid with a sour odour c. Light brown liquid with no distinguishable odour d. Light brown liquid with a strong pungent odour
17. 5.45 According to the International Safety Guide for Oil Tankers and Terminals (ISGOTT), for a tank to be safe for entry, what should the reading on a combustible gas detector be? a. Less than 15% b. Less than 10% c. Less than 1% d. Less than 0.5%
18. 5.38 A SDS will list what type of protective equipment is required when working with a particular material. a. True b. False
19. 5.84 What type of respirator filter cartridges should you use for protection against hydrogen sulfide? a. Acid Gas b. None. Only a self contained breathing apparatus is acceptable c. Organic Vapour d. Radionucleides, highly toxic dusts, mists and fumes
20. 5.20 To find out if a material is hazardous, you must consult the SDS. a. True b. False
ให้ตรวจสอบชื่อนามสกุลว่ากรอกครบหรือไหม่ พร้อมกับตรวจข้อสอบว่าเลือกทำครบทุกข้อหรือไม่ ไม่ครบไม่ตรวจนะครับ

แนะนำชุดข้อสอบ

1. แนวข้อสอบวิทยาศาสตร์ ประถมศึกษาปีที่ 4 ชุดที่ 1

2. แบบทดสอบหลังเรียน เรื่อง กีฬาแบดมินตัน

3. แบบทดสอบวิชาบาสเก็ตบอล

4. ข้อสอบ บรรจุครูผู้ช่วย วิชาเอก ปฐมวัย พร้อมเฉลย 50 ข้อ

นำแบบทดสอบไปติดที่เว็บของคุณ